Leak Defender RS for Well Pumps With House Alarm Connection

How it Works

When water is detected in your basement, Leak Defender RS suspends power to your well pump, stopping the flow of water from the well and triggers an audio alarm to alert you of the problem. It works with new or existing well pump systems, and it does not require an external power source. The well pump powers it. Once the leak has been stopped and sensors are dry, pressing a button on the sensor restores power to the well pump.

Unlike less reliable systems, Leak Defender RS does not use shutoff valves. Installation is easy and takes about 30 minutes.  It comes with two cable output connectors for multiple sensors, alarm module accessory and extension cables. This system uses a relay inline with the power either to a pressure switch or constant pressure controller for water pressure regulation.

Alarm Module

• Alarm Module uses a relay that will close a dry contact connected to a Normally Open connection to an alarm if a leak is detected and also will accept a Normally Open dry contact connection from the alarm to activate the system. 

• This option is supplied with a cable with flying leads for alarm connection. (See Alarm Module e-page for more info)

What's In The Box

• System control box

• One std water detection sensor with 6 ft long cable

• Cable with flying leads for alarm connection

• One Alarm Module Accessory (See Alarm Module e-page for more info)